Give Each Position a Job.
| Position | Models to Explore | Installation Checks |
|---|---|---|
| A-Pillars | ZL2 · Coming Soon | Plan both sides. Check windshield/hood reflections, door clearance, sightlines and cable routing. |
| Bumper | Z4i pods, Z8i, Z12i | Measure the opening, bracket interface, airflow space and access for aiming. |
| Roof / Rack | Z16i, Z20i | Verify both mounting supports, rack requirements, complete width, cable entry and roof/hood spill. |
A suggested location is not a vehicle-specific fitment claim. Stock mounting positions often require aftermarket brackets. Compare the actual dimensions with your vehicle and the bracket maker’s instructions before ordering.
Check the View from Both Front Seats.
A roof bar can light the hood, windshield or airborne material near the vehicle. A-pillar pods can reflect from bodywork or the edge of the windshield. Placement and aim can matter as much as the total output.
- Begin at a low output level in a controlled area with the vehicle stationary.
- Check forward visibility and reflections from the driver’s seat, then the passenger’s seat.
- Adjust aim and the contribution of individual Zenith channels. Compare the view again before saving a usable preset.
Channel control gives you another way to manage the distribution of light. It does not guarantee a glare-free installation; each combination of optics, mounting position and vehicle surfaces needs its own check.
Plan Around Your Platform.
Pickup Trucks
Check the bumper opening, grille clearance, cameras and other vehicle equipment. Longer bars on a roof or rack need mounts suitable for that structure and a protected path for the power cable.
UTVs
Look at the cage, roof, windshield and cabin together. Check helmet and sightline clearance, both front-seat views and the mounting structure. Vehicle electrical capacity can constrain the chosen output setting.
Jeep/Bronco
Compare bracket compatibility with the actual body, bumper, windshield and roof configuration. Confirm access to doors, panels and roof components that you use or remove.
Explore Your Vehicle Setup ↗Dry-Fit Before the Final Install.
Measure the light with the brackets you will use, and confirm the aiming range and connector clearance. Route cables so they are supported and protected through the full range of nearby moving parts. Follow the vehicle and bracket instructions.
Use real Race application photos for inspiration. Archive photos may show earlier hardware or custom fabrication, so use the current mounting guide for dimensions.
These lights are intended for off-road applications. Follow the rules that apply where you operate the vehicle, and use suitable lighting for other traffic.
Check Mounting DimensionsFurther reading: KC’s roof-light guide discusses placement and hood reflection. Race model recommendations and mounting data come from our own lineup.
