Race / Size & Fit

What Size Light Bar Do I Need?

Measure your usable mounting space first. Compare actual housing width and the bracket interface, then allow room for aiming, fasteners, cooling and the connector. Nominal bar size alone does not establish fit.

Black Zenith Z20i light bar with twenty modular optics
Actual Race product imagery. Explore the product page for the available configuration and finish choices.

Start with a Tape Measure.

A 20-inch light bar describes a size class. Your mounting opening needs to accommodate the actual light, its end-cap interface and the brackets you plan to use. An opening that matches the name on the box may still be too small.

  1. Measure the clear width, height and depth at the intended mounting position.
  2. Check the inside spacing of your brackets and where their bolts or slots meet the light.
  3. Allow room for aiming, connectors, cable bends, cooling and access to the fasteners.

Use the housing dimensions when mounting into your own brackets. If you use Race brackets, compare the complete installed envelope and bracket-hole centers too.

Compare the Four Bar Sizes.

SHO, VHO, UHO-SC and UHO-DC share the same external dimensions within each size. Choose the physical size first; then select the internal build and emitter color.

Zenith Bar Size and Housing Dimensions
Model / ClassHousing W × H × DEnd-Cap Faces Apart
Z8i / 20″21.5″ × 2.5″ × 3″21.5″
Z12i / 30″31.5″ × 2.5″ × 3″31.5″
Z16i / 40″41.5″ × 2.5″ × 3″41.5″
Z20i / 50″51.5″ × 2.5″ × 3″51.5″

Dimensions come from the current product catalog and supplied mounting assemblies. Check the full fitment guide for bracket-hole spacing and installed dimensions.

Open the Mounting Guide ↗

Match the Interface to Your Brackets.

End-cap spacing, bracket-hole centers and overall width with brackets are three different measurements. Tell your bracket supplier which one you have measured. A hole-center measurement alone does not describe the clearance between the brackets.

Z8i and Z12i are common starting points for bumper layouts. Z16i and Z20i are intended for larger roof or rack layouts. These are application directions; the actual vehicle, bumper or rack must support the assembly.

Go Deeper: What Should I Check on a Bracket Drawing?

Compare the mounting-face separation, hole or slot size, bolt compatibility, stand-off, aiming range and complete installed envelope. Check the bracket maker’s vehicle and load requirements. Ask Race to review the dimensions if any interface is unclear.

Make the Size Work Electrically.

A bar that fits physically still needs a suitable circuit. Larger and higher-output builds increase the electrical demand. Use your chosen tier in the wiring wizard before ordering, especially when reusing an existing harness.

For a compact bumper installation, also consider the Z4i pod. The coming-soon ZL2 is designed for A-pillar applications; final specifications will be published before ordering opens.

Plan Z8i Wiring