Lower Input Voltage Can Mean More Current.
For a constant-power load, input current is power divided by voltage at the light. Planning from battery voltage alone can understate the current when wiring losses lower the voltage at the light.
| Build | Input Limit | At 14 V at Light | At 11 V at Light |
|---|---|---|---|
| SHO | 600 W | 42.9 A | 54.5 A |
| VHO | 850 W | 60.7 A | 77.3 A |
| UHO-SC | 1,050 W | 75.0 A | 95.5 A |
| UHO-DC | 1,050 W | 75.0 A | 95.5 A |
Calculated input current, assuming the selected color/configuration reaches the listed cap. This is not a fuse-size or wire-ampacity recommendation. These voltages are measured at the light, not assumed at the battery.
Zenith maintains constant power down to 11 V, then linearly dims toward 0% at 10 V; 10.5 V corresponds to 50% output. The MCU’s response takes time, so a rapid voltage drop needs separate consideration from a steady-state calculation.
Include the Return Path and Every Connection.
The complete path includes the battery feed, fuse, relay contacts, light lead and return to the source. Voltage drops add across those parts while the light is loaded. A loose or unsuitable connection can be significant even when the wire gauge is large.
Use stranded copper automotive cable suitable for the installation. Copper-clad aluminum is not equivalent to copper at the same AWG and produces greater voltage drop for the same length and current. Check the cable and connector manufacturer’s ratings for temperature, current and environment.
Z8i–Z20i bars have 12-inch 8 AWG positive and return pigtails. Z4i uses 14 AWG connectors; R3 uses 18 AWG. The factory lead does not establish the size of an arbitrary extension. Enter each segment separately in the wizard, up to 15 ft for a one-way run.
Go Deeper: Why a Bigger Fuse Is Not the Fix
The fuse must protect the circuit’s conductors and components while accommodating the intended load. Raising its rating does not repair excessive resistance. Check voltage drop, wire capacity, the relay and each connection together. Use the wizard’s separate 11 V current and 9 V fuse-planning calculations, then verify component ratings and installation conditions.
Measure with the Light Operating.
- Record the battery voltage and the voltage directly across the light’s input at the same operating setting.
- Measure the voltage drop across the positive path and return path while loaded. This helps locate where the loss occurs.
- Inspect connections, fuse holders, relay contacts and cable routing using the correct isolation and test procedures. Repair the cause of abnormal loss or heating before returning to service.
An unloaded voltage reading does not show the voltage drop at operating current. If a circuit behaves differently as it warms up or when the engine speed changes, record those conditions too.
The vehicle must also have enough electrical capacity for the lights, its other loads and charging needs at the operating conditions you expect. Set an appropriate power limit when the full light output exceeds that budget.
Build a Wiring Plan Before Ordering.
Choose the exact model and output tier. Click each wire in the wiring diagram to set length and gauge, then inspect the calculated voltage and current at different battery voltages. The toggle-switch control feed comes from the ACC bus, keeping the low-current control path distinct.
Print the plan and its installation checklist for your installer. Confirm fuse, relay, conductor, terminal and connector ratings together; the worksheet helps organize the design but cannot inspect the actual installation.
Open the Wiring WizardSearch the detailed electrical FAQ for questions about fuses, relays, grounding, cable types and low-voltage behavior.
Reference principles: Blue Sea Systems: circuit protection and copper conductor resistance. Marine ampacity charts are not a substitute for the specifications of your automotive cable and installation.
